Perform this procedure to configure Quick Start to enter the setup mode through a single screen.
Procedure steps
|
|
|
| Step | Action |
|---|---|
|
|
|
| 1 |
From the navigation tree, double-click Administration. |
| 2 |
In the Administration tree, double-click Quick Start . |
| 3 |
In the IP/Community/Vlan work area, type a switch or stack IP address in the In-Band Stack IP Address dialog box. |
| 4 |
In the In-Band Stack Subnet Mask dialog box, type a subnet mask. |
| 5 |
In the Default Gateway dialog box, type an IP address. |
| 6 |
In the Read-Only Community String box, type a character string. |
| 7 |
In the Re-enter to verify dialog box immediately following the Read-Only Community String box, retype the character string from Step 6. |
| 8 |
In the Read-Write Community String dialog box, type a character string. |
| 9 |
In the Re-enter to verify dialog box immediately following the Read-Write Community String: box, retype the character string from Step 8. |
| 10 |
In the Quick Start VLAN dialog box, type a VLAN ID ranging from 1 to 4094. |
| 11 |
Click Apply . |
|
|
|
| --End-- | |
|
|
|