Configuring remote access using EDM

Use this procedure to configure remote access for a switch.

Procedure steps
Step Action
1

From the navigation tree, double-click Administration.
2

In the Administration tree, double-click Remote Access .
3

In the work area, click the Setting tab.

4

In the Telnet Remote Access Setting section, select a value from the Access list.
5

In the Telnet Remote Access Setting section, select a value from the Use List list.
6

In the SNMP Remote Access Setting section, select a value from the Access list.
7

In the SNMP Remote Access Setting section, select a value from the Use List list.
8

In the Web Page Remote Access Setting section, select a value from the Use List list.
9

In the SSH Remote Access Setting section, select a value from the Access list.
10

In the SSH Remote Access Setting section, select a value from the Use List list.
11

Click Apply .
--End--

Use the data in this table to configure remote access for a switch.

Variable definitions

Variable Value

Telnet Remote Access Setting

Specifies the remote access settings for telnet sessions.

  • Access—allows or disallows telnet access to the switch
  • Use List—enables (Yes) or disables (No) the use of listed remote Telnet information.

SNMP Remote Access Setting

Specifies SNMP remote access settings.

  • Access—allows or disallows SNMP access to the switch
  • Use List—enables (Yes) or disables (No) the use of listed remote SNMP information.

Web Page Remote Access Setting

Specifies web page remote access settings.

  • Use List—enables (Yes) or disables (No) the use of listed remote web page information.

SSH Remote Access Setting

Specifies SSH remote access settings.

  • Access—allows or disallows SSH access to the switch
  • Use List—enables (Yes) or disables (No) the use of listed remote SSH information.