You can use the Rate Limit tab to configure the Rate Limiting for a single port.
To open the Rate Limit tab:
Procedure steps
|
|
|
| Step | Action |
|---|---|
|
|
|
| 1 |
In the Device Physical Viewdouble-click the port. Multiple ports can be edited by selecting ports with the Control (CTRL) key depressed. |
| 2 |
From the Edit tree, double-click Chassis. |
| 3 |
From the Chassis tree, double-click Ports. |
| 4 |
Select the Rate Limit tab. |
|
|
|
| --End-- | |
|
|
|
The following table outlines the parameters for the Rate Limit tab.
Variable definitions
| Variable | Value |
|---|---|
| TrafficType | Specifies the two types of traffic that can be set with rate limiting: broadcast and multicast. |
| AllowedRate | Sets the rate limiting percentage. The available range is from 0% (none) to 10%. |
| Enable | Enables and disables rate limiting on the port for the specified traffic type. Options are true (enabled) or false (disabled). |