Saving the current configuration

The configuration currently in use on a switch is regularly saved to the flash memory automatically. However, you can manually initiate this process using the Save Configuration tab.

To save the current configuration:

Procedure steps
Step Action
1

From the navigation tree, double-click Edit.
2

From the Edit tree, double-click File System.
3

Select the Config/Image/Diag file tab.
4

Choose the Save Configuration tab.

The Save Configuration tab appears.

Note:

The shared graphic was removed in accordance with the NTDA for cloning of documents. The graphic that was removed was Edit_FileSystem_Save_Config.png
5

In the Action field, choose copyConfigToNvram.

6

Click Apply.
7

Click Refresh

The Status field displays the file copy progress.

--End--

The following table outlines the parameters for the Save Configuration tab.

Variable definitions

Variable Value
AutosaveToNvramEnabled Controls whether autosaving to NVRAM is enabled. Autosaving normally occurs periodically in a background task if any configuration changes have been made
Action Specifies where the current configuration file is saved. Only copyConfigToNvram is supported.
Status