Displaying the ADAC Ports tab

To open the ADAC Ports tab:

Procedure steps
Step Action
1

From the navigation tree, double-click Edit.
2

From the Edit tree, double-click ADAC.
3

Select the ADAC Portss tab.
--End--

The following table outlines the parameters of the ADAC Ports tab.

Variable definitions

Variable Value
Index Indicates the switch position in a stack and the port number. The default value for a standalone switch is 1.
AdminEnable Indicates whether ADAC is enabled (true) or disabled (false) for the port.
OperEnable Indicates whether the port ADAC operational state is true (enabled) or false (disabled). This is a read-only cell.
Attention

If OperEnable is false and AdminEnable is true, ADAC is disabled. This can occur if you reach the maximum number of devices supported on a port.

ConfigStatus Indicates the ADAC status for the port.
  • configApplied—the ADAC configuration is applied to the port.
  • configNotApplied—the ADAC configuration is not applied to the port.

This is a read-only cell.
TaggedFramesPvid Indicates the unique Port VLAN identifier (PVID). Values range from 0–4094. A value of 0 indicates that Auto-Configuration cannot change the PVID for the port.
TaggedFramesTagging Indicates the tagging value that Auto-Con figuration applies to a port that has ADAC enabled and has tagged frames selected as the operating mode.
  • tagAll—tagging is enabled on all frames
  • tagPvidOnly—tagging is enabled on frames with a PVID that matches the PVID of this port
  • untagPvidOnly—tagging is disabled on frames with a PVID that matches the PVID of this port
  • noChange—accepts frames without change
AdacPortType Indicates how ADAC classifies the port:
  • telephony—autodetection is enabled for the port
  • callServer—the port is configured as a Call Server
  • uplink—the port is configured as an Uplink
  • other—the port is not classified as telephony, callServer, or uplink
MacDetectionEnable Indicates whether Autodetection of Nortel IP Phones, based on MAC address is enabled (true) or disabled (false) on the interface.
Attention

You cannot configure MacDetectionEnable to false if no other supported detection mechanism is enabled on the port.
LldpDetectionEnable Indicates whether Autodetection of Nortel IP Phones, based on 802.1ab is enabled (true) or disabled (false) on the interface.
Attention

You cannot configure LldpDetectionEnable to false if no other supported detection mechanism is enabled on the port.