To view more topology information:
Procedure steps
|
|
|
| Step | Action |
|---|---|
|
|
|
| 1 |
From the navigation tree, double-click Edit. |
| 2 |
From the Edit tree, double-click Diagnostics. |
| 3 |
From the Diagnostics tree, double-click Topology. |
| 4 |
Select the Topology Table tab. |
|
|
|
| --End-- | |
|
|
|
The following table outlines the parameters of the Topology Table tab.
Variable definitions
| Variable | Value |
|---|---|
| Slot | The slot number in the chassis in which the topology message was received. |
| Port | The port on which the topology message was received. |
| IpAddr | The IP address of the sender of the topology message. |
| SegId (Slot/Port) | The segment identifier, slot , and port number from where the autotopology packets were received. |
| MacAddr | The MAC address of the sender of the topology message. |
| ChassisType | The chassis type of the device that sent the topology message. |
| BkplType | The backplane type of the device that sent the topology message. |
| LocalSeg | Indicates if the sender of the topology message is on the same Ethernet segment as the reporting agent. |
| CurState | The current state of the sender of the topology message. The choices are:
|