With the Local PoE tab, you can view LLDP PoE properties for the local system.
To open the Local PoE tab:
Procedure steps
|
|
|
| Step | Action |
|---|---|
|
|
|
| 1 |
From the navigation tree, double-click Edit. |
| 2 |
From the Edit tree, double-click Diagnostics. |
| 3 |
From the Diagnostics tree, double-click 802.1AB. |
| 4 |
From the 802.1AB tree, double-click Port dot3. |
| 5 |
Select the Local PoE tab. |
|
|
|
| --End-- | |
|
|
|
The following table outlines the parameters of the Port dot3 Local PoE tab.
Variable definitions
| Variable | Value |
|---|---|
| PortNum | Port number. |
| PowerPortClass | Identifies the port Class of the local port. |
| PowerMDISupported | Indicates whether MDI power is supported on the local port. |
| PowerMDIEnabled | Indicates whether MDI power is enabled on the local port. |
| PowerPairControlable | Derived from the value of the pethPsePortPowerPairsControlAbility object (defined in IETF RFC 3621), this value is used to indicate whether pair selection can be controlled on the local port. |
| PowerPairs | This object contains the value of the pethPsePortPowerPairs object (defined in IETF RFC 3621) for the local port:
|
| PowerClass | This object contains the value of the pethPsePortPowerClassifications object (defined in IETF RFC 3621) for the local port:
|