With the Neighbor Link Aggregate tab, you can view LLDP link aggregation properties for the remote system.
To view the Neighbor Link Aggregate tab:
Procedure steps
|
|
|
| Step | Action |
|---|---|
|
|
|
| 1 |
From the navigation tree, double-click Edit. |
| 2 |
From the Edit tree, double-click Diagnostics. |
| 3 |
From the Diagnostics tree, double-click 802.1AB. |
| 4 |
From the 802.1AB tree, double-click Port dot3. |
| 5 |
Select the Neighbor Link Aggregate tab. |
|
|
|
| --End-- | |
|
|
|
The following table outlines the parameters of the Port dot3 Neighbor Link Aggregate tab.
Variable definitions
| Variable | Value |
|---|---|
| TimeMark | The TimeFilter for this entry. |
| LocalPortNum | Identifies the local port on which the remote system information is received. |
| Index | An arbitrary local integer value used by this agent to identify a particular MSAP. An agent is encouraged to assign monotonically increasing index values to new entries, starting with one, after each reboot. |
| LinkAggStatus | Specifies the link aggregation capabilities and the current aggregation status of the remote link. |
| LinkAggPortId | Contains the IEEE 802.3 aggregated port identifier, aAggPortID (IEEE 802.3-2002, 30.7.2.1.1), derived from the ifNumber of the ifIndex for the port component in link aggregation. If the port is not in a link aggregation state or does not support link aggregation, this value is set to zero. |