Viewing LLDP neighbor PoE PD properties

With the Neighbor PoE PD tab, you can view LLDP PoE PD properties for the remote system.

To view the Neighbor PoE PD tab:

Procedure steps
Step Action
1

From the navigation tree, double-click Edit.
2

From the Edit tree, double-click Diagnostics.
3

From the Diagnostics tree, double-click 802.1AB.
4

From the 802.1AB tree, double-click Port MED.
5

Select the Neighbor PoE PD tab.
--End--

The following table outlines the parameters of the Port MED Neighbor PoE PD tab.

Variable definitions

Variable Value
TimeMark The TimeFilter for this entry.
LocalPortNum Identifies the local port on which the remote system information is received.
Index An arbitrary local integer value used by this agent to identify a particular MSAP. An agent is encouraged to assign monotonically increasing index values to new entries, starting with one, after each reboot.
PDPowerReq Specifies the value of the power required (in units of 0.1 watts) by a Powered Device (PD) connected remotely to the port.
PDPowerSource

Defines the type of Power Source advertised as being used by the remote device:

  • fromPSE: indicates that the device advertises its power source as received from a PSE.
  • local: indicates that the device advertises its power source as local.
  • localAndPSE: indicates that the device advertises its power source as using both local and PSE power.
PDPowerPriority

Defines the priority advertised as being required by the PD connected remotely to the port:

  • critical: indicates that the device advertises its power priority as critical, see RFC 3621.
  • high: indicates that the device advertises its power priority as high, see RFC 3621.
  • low: indicates that the device advertises its power priority as low, see RFC 3621.