Configuring the RADIUS server using EDM

Use the following procedure to configure the RADIUS server to store client or user credentials, password, and access privileges.

Procedure steps

Step	Action


1	From the navigation tree, double-click Security.
2	In the Security tree, double-click RADIUS .
3	In the work area, click the RADIUS Server tab.
4	Configure the RADIUS server parameters as required.
5	In the toolbar, click Apply.

--End--

Variable definitions

Use the data in the following table to configure the RADIUS server.

Variable

Value

PrimaryRadiusServer
AddressType

Specifies the type of primary IP address used by the Nortel SNAS 4050. Values are unknown, ipv4, and ipv6.

PrimaryRadiusServer

Specifies the IP address of the primary RADIUS server (default: 0.0.0.0).

Attention

If there is no primary RADIUS server, set the value of this field to 0.0.0.0 .

SecondaryRadiusServer
AddressType

Specifies the type of secondary IP address used by the Nortel SNAS 4050. Values are unknown, ipv4, and ipv6.

SecondaryRadiusServer

Specifies the IP address of the secondary RADIUS server (default: 0.0.0.0). The secondary RADIUS server is used only if the primary server is unavailable or unreachable.

RadiusServerUdpPort

Specifies the UDP port number (default: 1812). The port number can range between 1 and 65535.

RadiusServerTimeout

Specifies the timeout interval between each retry, for service requests to the RADIUS server. The default is 2 Seconds. The timeout period can range between 1 and 60 seconds.

SharedSecret(key)

Specifies the value of the shared secret key.

Attention

The shared secret key has a maximum of 16 characters.

ConfirmedSharedSecret
(key)

Confirms the value of the shared secret key specified in the SharedSecret(Key) field. This field usually does not display anything (just a blank field), and is used when you are changing the SharedSecret(key) field. You must enter the value twice to confirm the string is entered in SharedSecret(Key).