Use the SNMP tab to display read-only information about the addresses that the agent software uses to identify the switch.
Use the following procedure to view the SNMP information.
|
|
|
| Step | Action |
|---|---|
|
|
|
| 1 |
From the navigation tree, double-click Edit. |
| 2 |
In the Edit tree, double-click Chassis. |
| 3 |
In the Chassis tree, double-click Chassis. |
| 4 |
In the work area, click the SNMP tab to view SNMP information. |
|
|
|
| --End-- | |
|
|
|
The following table describes the fields of SNMP tab.
| Variable | Value |
|---|---|
| LastUnauthenticatedInetAddressType | Specifies the type of IP address that was not authenticated by the device last. |
| LastUnauthenticatedInetAddress | Specifies the last IP address that was not authenticated by the device. |
| LastUnauthenticatedCommunityString | Specifies the last community string that was not authenticated by the device. |
| RemoteLoginInetAddressType | Specifies the type of IP address to last remotely log on to the system. |
| RemoteLoginInetAddress | Specifies the last IP address to remotely log on to the system. |
| TrpRcvrMaxEnt | Specifies the maximum number of trap receiver entries. |
| TrpRcvrCurEnt | Specifies the current number of trap receiver entries. |
| TrpRcvrNext | Specifies the next trap receiver entry to be created. |