Viewing the IP Classifier Element tab

Prerequisites

Use the following procedure to open the IP Classifier Element tab.

Procedure steps
Step Action
1

From the navigation tree, double-click QoS.
2

From the QoS tree, double-click QoS Rules.
3

Select the IP Classifier Element tab.
--End--

Variable definitions

The following table outlines the parameters of the IP Classifier Element tab.

QoS Rules IP Classifier Element tab parameters

Variable Value
Id Specifies the number of the IP classifier element.
Name Specifies the IP classifier element name.
AddressType Specifies the type of IP address used by this classifier entry. The type is limited to IPv4 and IPv6 addresses.
DstAddr Specifies the IP address to match against the destination IP address of packet.
DstMaskLength Specifies the length of the destination address mask.
SrcAddr Specifies the IP address to match against the source IP address of packet.
SrcMasklength Specifies the length of the source address mask.
Dscp Specifies the value for the DSCP in a packet.
Protocol/NextHeader Specifies the IP protocol value.
DstL4Port Specifies the value for the Layer 4 destination port number in a packet.
SrcL4Port Specifies the value for the Layer 4 source port number in a packet.
IPv6Flowld Specifies the flow identifier for IPv6 packets.
IpFlags Specifies the value of flags present in an IPv4 header.
TcpCtrlFlags Specifies the control flags present in an TCP header.
Ipv4Options Specifies whether the Option field is present in the packet header. Valid values are
  • Present—indicates that only IPv4 packets with options match this classifier element.
  • Not Present—indicates that only IPv4 packets without options match this classifier element.
SessionId Specifies the session identification number.
Storage

Specifies the type of storage:

  • volatile
  • nonVolatile (default)
  • readOnly

This section contains information about the following topics:

Adding IP classifier elements

Prerequisites

Use the following procedure to add an IP classifier element.

Procedure steps
Step Action
1

From the navigation tree, double-click QoS.
2

From the QoS tree, double-click QoS Rules.
3

Select the IP Classifier Element tab.
4

Click Insert.

The Insert IP Classifier Element screen opens.

5

Enter the information you want to use for this IP classifier element.
6

Click Insert.
--End--

Deleting IP classifier elements

Prerequisites

Use the following procedure to delete an IP classifier element.

Procedure steps
Step Action
1

From the navigation tree, double-click QoS.
2

From the QoS tree, double-click QoS Rules.
3

Select the IP Classifier Element tab.
4

Highlight the IP classifier element to delete.
5

Click Delete.

Note:

An IP classifier element cannot be deleted if it is referenced by a classifier or classifier block. Additionally, an IP classifier element cannot be deleted if it is of the storage type of other or readOnly.

--End--