Viewing the L2 Classifier Element

Prerequisites

Use the following procedure to open the L2 Classifier Element tab.

Procedure steps
Step Action
1

From the navigation tree, double-click QoS.
2

From the QoS tree, double-click QoS Rules.
3

Select the L2 Classifier Element tab.
--End--

Variable definitions

The following table outlines the parameters of the L2 Classifier Element tab.

QoS Rules L2 Classifier Element tab parameters

Variable Value
Id Specifies the index that enumerates the classifier entries.
Name Specifies the Layer 2 Classifier Element name.
DstMacAddr Specifies the MAC address against which the MAC destination address of incoming packets are compared.
DstMacAddrMask Specifies a mask identifying the destination MAC address.
SrcMacAddr Specifies the MAC source address of incoming packets.
SrcMacAddrMask Specifies a mask identifying the source MAC address.
VlanId Specifies the value for the VLAN ID in a packet.
VlanTag

Specifies the type of VLAN tagging in a packet:

  • untagged
  • tagged
  • ignore
EtherType Specifies a value for the Ethertype.
802.1pPriority Specifies a value for the 802.1p user priority.
PktType Specifies the packet frame format.
  • etherII—indicates that only Ethernet II format frames match this classifier component.
  • snap—indicates that only EEE 802 SNAP format frames match this classifier component.
  • llc—indicates that only IEEE 802 LLC format frames match this classifier component.
Version Specifies the version.
SessionId Specifies the session identification number.
Storage Specifies the type of storage.

This section contains information about the following topics:

Adding L2 classifier elements

Prerequisites

Use the following procedure to add L2 classifier elements.

Procedure steps
Step Action
1

From the navigation tree, double-click QoS.
2

From the QoS tree, double-click QoS Rules.
3

Select the L2 Classifier Element tab.
4

Click Insert.

The Insert L2 Classifier Element dialog opens.

5

Enter the information to use for this L2 classifier element.
6

Click Insert.
--End--

For more information, see QoS Rules L2 Classifier Element tab parameters.

Deleting L2 classifier elements

Prerequisites

Use the following procedure to delete L2 classifier elements.

Procedure steps
Step Action
1

From the navigation tree, double-click QoS.
2

From the QoS tree, double-click QoS Rules.
3

Select the L2 Classifier Element tab.
4

Highlight any table cell of the L2 classifier element to delete.
5

Click Delete.

Device Manager deletes the entire L2 classifier element.

Note:

A L2 classifier element cannot be deleted if it is referenced by a classifier or classifier block. Additionally, a L2 classifier element cannot be deleted if it is of the storage type of other or readOnly.

--End--

For more information, see QoS Rules L2 Classifier Element tab parameters.