Viewing traffic profile sets

Prerequisites

Use the following procedure to open the Set tab.

Procedure steps
Step Action
1

From the navigation tree, double-click QoS.
2

From the QoS tree, double-click QoS NSNA/UBP/Traffic Profile.
3

Select the Set tab.
--End--

Variable definitions

The following table outlines the parameters of the Set tab.

QoS NSNA/UBP/Traffic Profile Set tab parameters

Variable Value
AclType Specifies the type of ACL (NSNA, UBP, or Traffic Profile).
Name Specifies a name for this entry. The name must be an existing classifier name. All classifiers with this name are part of this filter set. The filter set itself has this name.
IfIndex Specifies the logical interface index assigned to the VLAN or the physical interface.
MeteringMode Specifies the Traffic Profile metering Mode as:
  • noMetering
  • perPolicyUniformRateMetering
  • perPolicyIndividualRateMetring
  • perClassifierMetering
CommittedRate Specifies the committed rate (in Kbps).
BurstSize Specifies the maximum number of bytes in a single transmission burst.
OutActionDrop Specifies the action to take when packet is out-of-profile.

This action is applied only if metering is being enforced, and if the traffic is deemed out-of-profile based on the level of traffic and the metering criteria. (Metering is applied only to traffic matching the filtering data.)

Options are the following:

  • drop (packet is dropped)
  • pass (packet is not dropped)
OutActionUpdateDscp Specifies the action to take to update DSCP when a packet is out-of-profile.

The default value is -1. The value range is between -1–63.

SetPriority Specifies the priority in the range 1–255. You can only change this field for a User Based Policy set. .
Status Enables or disables the Traffic Profile set policy. .
Storage Specifies the type of storage for this entry.

This section contains information about the following topcis:

Configuring a set

Prerequisites

Use the following procedure to configure a set.

Procedure steps
Step Action
1

From the navigation tree, double-click QoS.
2

From the QoS tree, double-click QoS NSNA/UBP/Traffic Profile.
3

Select the Set tab.
4

Click Insert.

TheInsert Set dialog box opens.
5

Enter the set information in the fields.
6

Click Insert.
--End--

Deleting a set

Prerequisites

Use the following procedure to delete a set.

Procedure steps
Step Action
1

From the navigation tree, double-click QoS.
2

From the QoS tree, double-click QoS NSNA/UBP/Traffic Profile.
3

Select the Set tab.
4

Select a set to delete.
5

Click Delete.
--End--

Filtering a set

Prerequisites

Use the following procedure to filter a set.

Procedure steps
Step Action
1

From the navigation tree, double-click QoS.
2

From the QoS tree, double-click QoS NSNA/UBP/Traffic Profile.
3

Select the Set tab.
4

Select a set to filter.
5

Click Filter.

6

Set the filter parameters in the dialog.
7

Click Filter.
--End--