Use the following procedure to view read-only Link Aggregation Control Protocol (LACP) diagnostic statistics.
| Attention The Marker Protocol Generator/Receiver is currently not a supported feature. |
|
|
|
| Step | Action |
|---|---|
|
|
|
| 1 |
In the Device Physical View, select one or multiple ports. |
| 2 |
From the navigation tree, double-click Graph. |
| 3 |
In the Graph tree, double-click Port. |
| 4 |
In the work area, click the LACP tab to view information about LACP diagnostic statistics. |
|
|
|
| --End-- | |
|
|
|
The following table describes the fields of LACP tab.
| Field | Description |
|---|---|
| LACPDUsRX | Denotes the number of valid LACPDUs received on this Aggregation Port. This value is read-only. |
| MarkerPDUsRX | Signifies the number of valid Marker PDUs received on this Aggregation Port. This value is read-only. |
| MarkerResponsePDUsRX | The number of valid Marker Response PDUs received on this Aggregation Port. This value is read-only. |
| UnknownRX | Indicates the number of frames received that can
|
| IllegalRX | Denotes the number of frames received that carry the Slow Protocols Ethernet Type value (43B.4), but contain a badly formed PDU or an illegal value of Protocol Subtype (43B.4). This value is read-only. |
| LACPDUsTX | Signifies the number of LACPDUs that are transmitted on this Aggregation Port. This value is read-only. |
| MarkerPDUsTX | Displays the number of Marker PDUs transmitted on this Aggregation Port. This value is read-only. |
| MarkerResponsePDUsTX | Indicates the number of Marker Response PDUs that are transmitted on this Aggregation Port. This value is read-only. |