Use the following procedure to modify an IPFIX collector.
|
|
|
| Step | Action |
|---|---|
|
|
|
| 1 |
From the navigation tree, double-click Serviceability. |
| 2 |
In the Serviceability tree, double-click IPFIX. |
| 3 |
In the work area, click the Collectors tab. |
| 4 |
In the table, double-click a cell under the column heading for the parameter you want to change. |
| 5 |
Select a parameter or value from the drop-down list. |
| 6 |
Repeat the previous two steps until you have amended all of the parameters you want to change. |
| 7 |
In the toolbar, click Apply. |
|
|
|
| --End-- | |
|
|
|
The following table describes the fields of Collectors tab.
| Field | Description |
|---|---|
| Slot | Indicates the unit number of the collector. Currently up to two collectors are supported. |
| AddressType | Indicates the address type of the IP address of the collector. Currently only IPv4 addresses are supported. |
| Address | Indicates the IP address of the collector. |
| Protocol | Indicates the protocol used to transport the IPFIX data to the collector. Currently only the UDP protocol is supported for this task. |
| DestPort | Indicates the port on which the collector is listening for IPFIX data. Currently only port 9995 is supported for this task. |
| ProtoVer | Indicates the format in which IPFIX data is provided to the collector. Currently only Netflow version 9 formatting is supported for this task. |
| Enable | Indicates the operational state of this collector. |