Use the SNMP tab to display read-only information about the addresses that the agent software uses to identify the switch.
View the SNMP information by following this procedure:
Procedure steps
|
|
|
| Step | Action |
|---|---|
|
|
|
| 1 |
Select a chassis in the Device View. |
| 2 |
Select Edit, Chassis from the Device Manager menu. |
| 3 |
Click the SNMP tab. |
|
|
|
| --End-- | |
|
|
|
Use the data in this table to display read-only information about the addresses that the agent software uses to identify the switch.
| Variable | Value |
|---|---|
| LastUnauthenticatedInetAddressType | Specifies the type of IP address that was not authenticated by the device last. |
| LastUnauthenticatedInetAddress | Specifies the last IP address that was not authenticated by the device. |
| LastUnauthenticatedCommunityString | Specifies the last community string that was not authenticated by the device. |
| RemoteLoginInetAddressType | Specifies the type of IP address to last remotely log on to the system. |
| RemoteLoginInetAddress | Specifies the last IP address to remotely log on to the system. |
| TrpRcvrMaxEnt | Specifies the maximum number of trap receiver entries. |
| TrpRcvrCurEnt | Specifies the current number of trap receiver entries. |
| TrpRcvrNext | Specifies the next trap receiver entry to be created. |