The following table describes the Interfaces tab fields.
| Field | Description |
|---|---|
| IfIndex | Specifies the VLANs configured for PIM-SM. |
| Address | Specifies the IP address of the PIM-SM VLAN. |
| NetMask | Specifies the network mask for the PIM-SM VLAN. |
| Enable | Specifies the status of PIM-SM on the VLAN: enabled (true) or disabled (false). |
| Mode | Specifies the PIM mode. The Ethernet Routing Switch 5000 Series Software supports only the sparse mode. |
| DesignatedRouter | Specifies the router with the highest IP address on a LAN designated to perform the DR tasks. |
| HelloInterval | Specifies the interval (in seconds) the switch waits between sending hello message to neighboring switches. The default is 30 seconds. |
| JoinPruneInterval | Specifies the interval (in seconds) the switch waits between sending join/prune message to its upstream neighbors. The default is 60 seconds. |
| CBSRPreference | Specifies the preference for this local interface to become a C-BSR. The C-BSR with the highest BSR-priority and address is
the preferred BSR. The default is –1, which indicates that the current interface is not a C-BSR. |
| InterfaceType | Specifies the type of interface: active or passive. |
| OperState | Indicates the operating status of PIM-SM on this interface: up or down. |