Variable definitions

Variable Value
AclType Specifies the type of ACL (NSNA or UBP).
Name Specifies a name for this entry. The name must be an existing classifier name. All classifiers with this name are part of this filter set. The filter set itself has this name.
IfIndex Specifies the logical interface index assigned to the VLAN.
CommittedRate Specifies the committed rate (in Kbps).
BurstSize Specifies the maximum number of bytes in a single transmission burst.
OutActionDrop Specifies the action to take when packet is out-of-profile.

This action is applied only if metering is being enforced, and if the traffic is deemed out-of-profile based on the level of traffic and the metering criteria. (Metering is applied only to traffic matching the filtering data.)

Options are the following:

  • drop (packet is dropped)
  • pass (packet is not dropped)

The default value is pass.

NonMatchActionDrop Specifies the action to take when a packet is non-matching. This action is applied to all traffic that was not previously matched by the specified filtering data.

Options are the following:

  • drop (packet is dropped)
  • pass (packet not dropped)
  • defer (no explicit drop/pass action is specified; the decision is deferred)

The default value is defer.

OutActionUpdateDscp Specifies the action to take to update DSCP when a packet is out-of-profile.

The default value is -1. The value range is between -1–63.

SetPriority Specifies the priority in the range 1–255.
Storage Specifies the type of storage.