
                     LNEPCI II Setup Program Help Message
A.Configure the Card:
  (a) Set Configuration Registers
      --> mode configuration
          (When LAN card numbers are more than one,users will be
           asked which card will be shown. Users just input the
           card number that is needed.)

  (b) Show Configuration Registers
      --> (1) mode configuration
              (When LAN card numbers are more than one,users will be
               asked which card will be shown. Users just input the
               card number that is needed.)

          (2) PCI configuration
              (When LAN card numbers are more than one,users will be
               asked which card will be shown. Users just input the
               card number that is needed.)

  (c) Set Board Number
      (The item is just shown when LAN card numbers are more than one )
      --> When users choose one of both/all demo boards, the following
          items are demonstrated in the board that users select.
          For instance, 3 LAN cards exist. Users choose the second card.
          All the following items will be demonstrated in the second card.
          When users want to change to the third board, users will select
          the third board by this item.

B.Diagnose:
                       Reset Test
                       Register Test
                       Remote DMA Test
                       Loopback All Test
                       Loopback 1 Test

                       Loopback 2 Test
                       Loopback 3 Test

C.Transmit/Receive Packet:
  Used to check for communication over the network cable.

                       Transmit Packets
                       Receive Packets
                       Transceive

D.Show Physical Address: 
  To show users the LAN card physical address

E.Reset Winbond:
  By this item, the controller chip will be reset.

** Before leaving this program, users will be asked whether to choose
   Frame Type in NET.CFG. If the card numbers are more than one, all
   information will be generated in NET.CFG file.  Diskette may not be
   write-protected for the file to be generated.
