Configuring link-state tracking using ACLI

Use this procedure to configure link-state tracking.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. At the command prompt, enter the following command:

    [default][no] link-state group <1–2> {{upstream | downstream} interface {Ethernet <portlist> | mlt <1–32>} | enable}

Variable definitions

The following table describes the parameters for the link-state command.

Variable Value
default Disable link-state setting.
no Remove interface from group.
group <1–2> Specifies the group id.
downstream Specifies to configure interface to downstream set.
upstream Specifies to configure interface to the upstream set.
interface Ethernet <portlist> Specifies the list of ports in the interface.
interface mlt <1–32> Specifies the trunk number in the interface.
enable Enables or disables (when used with the no parameter) link-state tracking for the specified group.
Comments?
March 2013
©2013, Avaya Inc. All Rights Reserved.