Displaying link-state tracking information using ACLI

Use this procedure to display link-state tracking information.

Procedure

Log on to ACLI to enter User EXEC mode.
At the command prompt, enter the following command:
show link-state [group <1–2>] [detail]

The following table describes the parameters for the show link-state command.

Variable	Value
group `<1–2>`	Specifies the group. If this parameter is not specified, both groups are displayed.
detail	Displays tracking group detailed information. If this parameter is not specified, the switch displays tracking group status (enabled/disabled) and operational status (up/down).