Configuring remote access

Use the following procedure to configure remote access for a switch or stack.

Procedure

From the navigation tree, double-click Administration.
In the Administration tree, click Remote Access.
In the work area, click the Setting tab.
In the Telnet Access Setting section, select a value from the Access list.
In the Telnet Access Setting section, select a value from the Use List list.
In the SNMP Remote Access Setting section, select a value from the Access list.
In the SNMP Remote Access Setting section, select a value from the Use List list.
In the Web Page Remote Access Setting section, select a value from the Use List list.
In the SSH Remote Access Setting section, select a value from the Access list.
Note
SSH Remote Access is only available in secure software builds.
In the SSH Remote Access Setting section, select a value from the Use List list.
Note
SSH Remote Access is only available in secure software builds.
On the toolbar, click Apply.

The data in the following table describes configuring remote access for a switch or stack using EDM.

Variable

Value

Telnet Remote Access Setting

Specifies the remote access settings for telnet sessions.

If you need to describe a series of choices for the field, use an unordered list as follows:

Access: allows or denies telnet access to the switch or stack.
Use List: Enables (Yes) or disables (No) the use of remote access list Telnet information.

SNMP Remote Access Setting

Specifies the remote access settings for SNMP.

If you need to describe a series of choices for the field, use an unordered list as follows:

Access: allows or denies SNMP access to the switch or stack.
Use List: Enables (Yes) or disables (No) the use of remote access list SNMP information.

Web Page Remote Access Setting

Specifies the remote access settings for Web Page.

If you need to describe a series of choices for the field, use an unordered list as follows:

Use List: Enables (Yes) or disables (No) the use of remote access list web page information.

SSH Remote Access Setting

Specifies the remote access settings for SSH.

	Note
	SSH is only available in secure software builds.

If you need to describe a series of choices for the field, use an unordered list as follows:

Access: allows or denies SSH access to the switch or stack.
Use List: Enables (Yes) or disables (No) the use of remote access list SSH information.

	Note
	SSH Remote Access is only available in secure software builds.