Use the following procedure to configure ADAC parameters for the
switch.
 | Note |
|
When executing the script using EDM, do not run other commands
while the script is in progress, as this slows down the execution.
EDM can time-out while waiting for a response; even when a time-out
occurs, the script execution continues on the switch.
|
Procedure
- From the navigation
tree, double-click Administration.
- In the Administration
tree, click Run Script.
- In the work area, click
the ADAC Script tab.
- In the Verbose section,
in the Data VLAN ID field, type the data VLAN
ID.
- Select Management
VLAN flag if you want the data VLAN as the management
VLAN.
- In the Data
VLAN Gateway dialog box, type the data VLAN Gateway IP
address.
- In the Data
VLAN Gateway Mask dialog box, type the data VLAN Gateway
mask address.
- In the Management
IP address dialog box, type the management IP address.
- In the Management
IP Mask dialog box, type the management IP mask.
- In the Default
IP Route dialog box, type the default IP route address.
- In the Voice
VLAN Id dialog box, type the voice VLAN ID.
- In the Voice
VLAN Gateway dialog box, type the IP address.
- In the Voice
VLAN Gateway Mask dialog box, type the IP mask address.
- In the LLDP
Call-Server dialog box, type the LLDP call server IP
address.
- In the LLDP
File-Server dialog box, LLDP file server IP address.
- (Optional) Select the Uplink trunk flag to link ADAC uplink port as a member
of MLT trunk.
- Click the ADAC Uplink Ports ellipsis (...).
- From the ADAC Uplink
Ports, select the uplink ports and then, click Ok.
- Click the ADAC Call Server Ports ellipsis (...).
- From the ADAC Call
Server ports, select the call serevr ports and then, click Ok.
- Click the ADAC Telephony Ports ellipsis (...).
- From the ADAC Telephony
Ports, select the telephony ports and then, click Ok.
- Click Apply.
