 |  |
Configuring source interface
About this task
Use the following procedure to set a loopback interface IP as source IP address for a specific application.
Procedure
- From the navigation tree, double-click IP.
- In the IP tree, click IP.
- In the work area, click the Source Interface tab.
- In the table, double-click the cell under the InterfaceType column heading for setting a CLIP interface.
- Click loopback.
- Repeat steps 4 and 5 as required.
- In the table, double-click the cell under the InterfaceId column heading.
- Type a numerical value from 1 to 16.
- Repeat steps 7 and 8 as required.
- On the toolbar, click Apply.
Variable definitions
The following table describes the fields for the Source Interface tab
| Field | Description |
|---|---|
| AppId | Indicates the source interface for radius, syslog, tacacs, snmp-traps, ssh, and telnet. |
| InterfaceType | Indicates the interface type and you can assign loopback for the source interface. |
| InterfaceId | Indicates the loopback interface identifier. Values range from 1 to 16. |