ContentsPrint

Specifying an IP address to be allowed to flood a VLAN using EDM

Use this procedure to configure the IP address multicast filter table. This table specifies multicast IP addresses that can be flooded to all ports on a per-VLAN basis.

Procedure steps

  1. From the navigation tree, double-click VLAN.

  2. In the VLAN tree, double-click VLANs.

  3. In the work area, click the IP Address Multicast Filter Table tab.

  4. Click Insert

  5. Complete the fields as required.

  6. Click Insert

Variable definitions

The following table describes the fields of the IP Address Multicast Filter Table tab.

Field Definition
VlanAllowedInetAddressVlanId Specifies the ID of the VLAN to configure.
VlanAllowedInetAddressType Specifies the address type: ipv4.
VlanAllowedInetAddress Specifies a multicast IP address that can flood all ports. You cannot specify unicast or broadcast addresses.
Comments on this document?
October 2015
© 2012-2015, Avaya, Inc. All Rights Reserved.