ContentsPrint

Viewing RTP results

Use this procedure to view the results of a real time protocol test.

Procedure

  1. From the navigation tree, double-click Serviceability.
  2. In the Serviceability tree, click SLA Monitor.
  3. In the SLA Monitor work area, click the RTP tab.
  4. Click Results.

RTP Results field descriptions

Name Description
OperStatus Indicates the status of an RTP test.

  • inProgess: test is active

  • aborted: test has been stopped. Refer to AbortData for details.

  • completed: test is completed
SrcAddress Indicates the source IP address used for the RTP test.
SrcPort Indicates the port used for the RTP test.
DstAddress Indicates the destination IP address used for the RTP test.
DstPort Indicates the destination port used for the RTP test.
Dscp Specifies the Differential Services Code Point (DSCP) value for use in packets that are generated by the RTP test.
AverageDelay Indicates the average network delay (RTT) experienced during the RTP test execution in microseconds.
MedianDelay Indicates the median network delay (RTT) experienced during the RTP test execution in microseconds.
PacketLoss Indicates the count of packets lost during an RTP test execution.
OutOfOrderArrivals Indicates the count of packets arriving out-of-order during an RTP test execution.
JitterQuartile0 – JitterQuartile4 Indicates the resulting quartile boundaries after sorting the network jitter values of all test packets during the RTP test execution. The value is represented in microseconds.
AbortData Indicates the details of the RTP test that was aborted. Values can include more than one of the following:

  • other

  • agentDisabled

  • agentBusy

  • timeout

  • cancelled

  • deniedByTarget

  • networkIssue

  • timeSync
Comments on this document?
October 2015
© 2012-2015, Avaya, Inc. All Rights Reserved.